| Each side panel gets cut from one 4x12 sheet of 1/4" plywood.
|
| Each side panel is 26" at the front end and 22" at the rear end.
|
| Snap a diagonal line down the middle of the sheet from 22" from one
|
| edge at one end, to 26" from the same edge at the other end.
|
| Then flip one side over before making the layouts, so the layout
|
| lines are pencilled in on the inside of each matching panel.
|
|
|
| The layout starts at 0" at the front end. The first mark at 12"
|
| marks the start of the chine. Then layouts at 36" 60" and
|
| 72" mark stations #1 #2 and #3. The front edge of each station
|
| lines up with the layout marks, hence the "X's" on the side panel
|
| drawing, on the rear facing edge of each layout mark.
|
|
|
| The last layout mark at 134" marks the end of the chine.
|
|
|
Green one
Rowers Seat/
Stations Transoms/
front
gussets
rear
white buffaloboat
wood Buffaloboat